JFC 3P mate
The JFC 3P mate plugs in to the JFC 3P connector used on several sensors. This mate is the side that is built in to the sensor,
and can be used for adapting sensors or making breakout harnesses. The connectors are sealed if the wire seals are used. But there
is an option of a rubber boot for extra protection from damage.
The connectors comes with the housing, terminals, and wire seals. The long rubber boot shown is not included, but is available as an option.
The standard seal included is the white seal which will work for most 18 or 20 gauge wire.
To find the proper seals for your application, check
here.
The mating connector to this one is available
here.
Where used:
DSM 1990:
DSM 1991-1994:
DSM 1995-1996: VSS, MDP
DSM 1997-1999: VSS, MDP
CSM:
Galant:
3S: VSS, MDP(96+), PTU
